Manufacturing to your drawing

If you already have a drawing, this is the shortest route. Drawing in, quotation out, and nothing is machined until you have signed the drawing off.

Formats and what we check

PDF, DWG, DXF, STEP or IGES all work. Paper drawings are fine if they are legible. Before quoting we check the interface threads, the port positions, the mounting hole centres, the material specification and the tolerances that actually matter for function — not every dimension carries the same weight.

We confirm in writing before cutting

If anything is ambiguous or missing, we ask rather than assume. You get a written confirmation of the dimensions we intend to hold. This step exists because a wrong assumption discovered after machining costs both of us a month.

Tolerances and surface finish

Bores are machined on horizontal machining centres, so position and diameter tolerances are held by the machine rather than by hand fitting. Sealing faces and spool bores are finished to the drawing requirement; if the drawing does not state a finish, we will agree one with you rather than pick our own.

Materials

Body material is usually specified by the drawing. Where it is not, we will propose one and explain the trade-off — corrosion resistance, machinability, cost and availability all pull in different directions. Material certificates can be supplied with the shipment.

Send a drawing

Attach the drawing or send a part number and we will come back with a quotation and, where useful, a note on anything we would change to make the part easier or cheaper to produce. Start a quotation.